Thread: Ghe770
View Single Post
Old 02-10-2014, 12:38 PM   #171
ghetto3
Senior Member
 
ghetto3's Avatar
 
Join Date: Sep 2011
Location: north coast nsw
Car: 97 ba 1.8 323
Posts: 799


while the head has been off I have been neatening up all of this stuff.
The clutch reservoir is a billet ring bros. item ,sitting low in its bracket, you can see what im planning here. I'd need to plug the original barb on the brake reservoir there. The problem was the clutch res. line swept around the booster and gets too close to the sausage filter so I've tried to thread it straight up over the booster and fit the custom res. there. I need a 45* barb fitting to make it work.

The alt. mount is a small block chev kit that I got for cheap and hacked up to suit.
I might need a check valve in the booster line there and the whole thing might need to be reconfigured yet if I decide to run a map sensor too.
keeping at it guys.

Last edited by ghetto3; 02-10-2014 at 12:41 PM.
ghetto3 is offline   Reply With Quote