Thread: Mats new BF
View Single Post
Old 11-08-2014, 08:32 AM   #105
Mad Mat
HONEYWELL REPRESENT
 
Mad Mat's Avatar
 
Join Date: Aug 2005
Location: Salisbury - Inner City
Car: 1997 BA Hardtop - Had a 2003 BJii J48 Sport20, and 2x bg SOHC astina hatches
Posts: 5,011
Send a message via MSN to Mad Mat
UPDATE,

so over the past few months i have been collecting parts for this car and slowly building it up and up.. so a few months ago I got a chance to buy a f2t engine package from a friend. So after a long and hard think about it (literally lasted 3sec’s) I said yer sure why not, how hard could it be to install..
have had the motor in my garage now for a good 2-3 months and I have been thinking about how I was going to get it to fit.. long story short with out making custom driveshafts to convert the 28spline outer cv’s to 26 spline to fit mazda 323 hubs (v6 or I4) it wasn’t going to happen.. so I have decided to go a different route.
Engine build 2.0:
- Mazda BA BP 1.8 engine
- Mx5 10.5:1 cp pistons from a 2001-2005 BP
- Mild cams
- Cam gears
- BA intake manifold
- BA series 3 ECU, Loom, dizzy, injectors
- FPR (to help with the Higher comp)
- Extractors
- Mazda BG g series box with B6T final drive
- Mazda BG g series driveshafts
- Civic Rad
- Ported and polished head
- Mx5 1.6 flywheel kit

I will be making a patch loom for my 420E ECU so i can run that later on down the tract and run some Toyota COPS too but will still keep the standard BA S3 engine loom so it looks factory-ish
__________________

1994 323 BG Hatch 2005-2007 Crashed into truck
1991 323 BG Hatch 2007-2008/9 SOLD
2003 BJ SP20 J48 Hatch 2008-2011 Regretfully SOLD
1997 BA I4 Sedan 2012-CURRENT
1985 BF 323 Hatch 2014-2015
SOLD
1989 MX5 2015-2015
Mad Mat is offline   Reply With Quote