|
yepp, used the oven, 50 degrees was a tad cold, so put it up to about 70 degrees for 5 or 10 minutes... goes nice and gooey then.
lift the tabs and pry off (used a butter knife) managed to move the lens off about 5mm the entire way around, then the sealant was cooling and getting hard again, so chucked it back in the oven for 5mins, then came of fairly easily.
Just make sure that you take the tiny little Phillips head screw out... On the sp20 lights its on the corner of the outer edge (if that makes sense)
And to re seal... DO NOT PUT MORE ADHESIVE ON!!!
because when you push the two sections together, its just going to ooze out onto the inside of the lense...
What i did was just re asseble lights, push together by hand as much as possible... in the oven (at 70 degrees) for 5 mins, then push the rest together.. should go fairly easily and allow to cool.
__________________
|