|
06-04-2012, 05:27 PM | #1 |
Junior Member
Join Date: Feb 2012
Location: Australia
Car: 1996 Mazda 323 BA Astina
Posts: 5
|
Stereo sound issues
Hey all.
So I have a question that I'm not sure if anyone has an answer or if its been asked before. I have pulled out and re-installed my stereo system like 10 times, I've rewired over and over and I don't use any of the origanal wiring for the sound system except power, accessory and earth. ISSUE: When I start the car I get a high pitch whistle through my speakers and it gets louder as the rpm climbs up. Any ideas? Help is much needed, due to its doing my head in. Cheers. BTW its a "96" BA 323 Astina hatch. |
Sponsored Links |
06-04-2012, 06:05 PM | #2 |
Senior Member
Join Date: Jun 2011
Location: Sunshine Coast
Car: MPS
Posts: 1,939
|
Its a ground problem. Generally its between the stereo and a amp if you run the power cables with the stereo cables together. Your meant to run the cables on the opposite side of the car...
However, you can buy a ground loop isolator and it will fix it... There about $20ish from jb. Or find a better ground source... Last edited by Ben; 06-04-2012 at 06:10 PM. |
06-04-2012, 07:20 PM | #3 |
Junior Member
Join Date: Apr 2009
Location: Newcastle NSW
Car: 97 BA 323 Astina Hatch
Posts: 211
|
I agree. I always run the power cable and RCA leads down opposite sides and the speaker wires down the middle.
__________________
--------------------------------------------------- 1997 BA 1.8 Astina Hatch |
06-04-2012, 07:20 PM | #4 | |
Senior Member
Join Date: Dec 2011
Location: Adelaide
Car: 2000 Mazda BJI Protege
Posts: 878
|
Quote:
I simply ran a ground wire from the amp directly to the battery and that sorted the issue - gave the cleanest possible ground.
__________________
2010-2014: 2000 Mazda 323 Protege 2014 - 2016: 1991 Toyota MR2 SW20 2016 - Err, 2016: 2002 Mazda 323 Astina SP20 2016 - Err, uh, 2016: 1991 Mazda MX5 NA 2016 - 2017: 2000 Alfa 916 Spider 2017 - 2018: 2007 Alfa Brera 2018 - Current: 2018 Mazda 3 SP25 |
|
06-04-2012, 08:03 PM | #5 |
Banned
Join Date: May 2006
Location: Brisneyland, Queensland
Car: 2002 Mazda Frankenstina
Posts: 2,868
|
You can also run an extra earth return from a nice clean bolt to the earth terminal.
This is a must as every wire off the positive terminal should have an equal sized one on the negative. Another way of fixing it is all car stereo items run a common earth point. Amp and headunit all earthed to the same spot. |
06-04-2012, 11:41 PM | #6 |
Junior Member
Join Date: Aug 2011
Location: Radelaide's WestSide
Car: 89 Astina BG DOHC
Posts: 172
|
Pretty much what xeon said, but go to the earthing bolt that the battery uses for a separate ground that should remove any hissing you get.
|
07-04-2012, 06:02 AM | #7 |
Junior Member
Join Date: Feb 2012
Location: Australia
Car: 1996 Mazda 323 BA Astina
Posts: 5
|
Thanks for the help guys. All though my power wire speaker wire and RCA are all separate until they get to the amp that's where they all meet up and I just ground the amp to a bolt in the back of the car. But if what your saying is right I'll try that. After all I have all the equipment to do them all and my loop issolator is on its way
|
07-04-2012, 07:12 AM | #8 |
Senior Member
Join Date: May 2005
Location: Sydney Lakemba
Car: mx-6 626 Gs300 Maz2 was 95 KF BA-HT
Posts: 2,024
|
Sometimes you also get it where poor quality RCA's are used. Like it's been said ground loop. THe grounding of the RCA's is poor can also give this effect, I've seen it on some installed where they have done it all correct -- power on one side RCA's and line level another.
It's normally at the ends of the RCas that go but I have seen where some installed have put them right under where feet go and they break and wear. |
25-06-2012, 02:40 PM | #9 |
Junior Member
Join Date: Feb 2012
Location: Sydney
Car: Mazda SP20
Posts: 240
|
is the head unit Pioneer?
__________________
Hustle and Flow |
25-06-2012, 06:47 PM | #10 |
Senior Member
Join Date: Jan 2012
Location: Beachmere
Car: 1997 BA "The Red Baron"
Posts: 704
|
I have that problem with my sub, haven't been bothered to fix it yet, but you can put on a low pass filter and that removes the problem, however it does remove all the high frequinces, you could just leave it and pretend its a supercharger
|
27-06-2012, 11:22 AM | #11 |
Junior Member
Join Date: Feb 2012
Location: Sydney
Car: Mazda SP20
Posts: 240
|
LOL supercharger... I was told by my cousin that with Pioneer head units if you don't plug in the power last you get that engine noise...
__________________
Hustle and Flow |
|
|