|
18-04-2011, 04:23 PM | #1 |
Junior Member
Join Date: Oct 2010
Location: Durban, South Africa
Car: 1996 Mazda Astina 180i se BA
Posts: 67
|
the same old q, just need confirmation
hey guys,
i seem to be posting alot of q here, and always seem to get the answers i need. so mind me every now and again, if i repeat any previously answered threads, just trying to get the astina running 110% before doing any serious power mods. So anyways here goes, when setting the base idle (cos i have been hearing many variations in the steps, just want to know which is the correct way) Case one 1. warm engine up, and switch off 2. bridge GND & TEN , and then start car, 3. wait for the idle to settle, and then adjust the idle air screw 4. switch car off, and remove jumper 5. restart and check if the adjustment was correct Case Two 1. warm car up and let it idle, while bridging the GND &TEN 2. adjust idle air screw 3. remove jumper, and then switch the off then restart to check adjustment was correct. NB, Some people have even told me to unplug the IAC connector cable whilst the jumper is in, and then reconnect once idle is set. SO please help guys, which method above is the correct way? or if I have missed out anything, please advise. and is there any truth to removing the IAC connector cable whilst setting the base idle. thanks for the help guys much appreciated. Kind regards
__________________
Mazdasport Last edited by mazdasport; 18-04-2011 at 04:25 PM. Reason: spelling errors |
Sponsored Links |
|
|