View Single Post
Old 09-11-2012, 02:23 PM   #25
himynameisbunny
AstinaGT Regular
 
himynameisbunny's Avatar
 
Join Date: Jul 2012
Location: Sutherland Shire, Sydney, AUS
Car: 97 Astina BA
Posts: 432
Quote:
Originally Posted by Clean_Cookie View Post
a few differences. BPT block has oil galleries which the BP are moulded shut...mat discovered this last week. but tapping off the oil filter relocation kit you will install should be just as effective.

Im doing this
Not too sure what you mean in regards to what you're doing with the relocation kit. Might just be because I'm sick again.

Quote:
Originally Posted by Mad Mat View Post
its easier to turbo ur na motor.. motor swaps are just to hard in NSW..

u can buy mx5 1.8 forged pistons and they will work in our bp motors. as they are all the same (basically).

this is what im doing next month

ur better off getting forged gear rather than using used bpt rods and pistons..
Interedasting.

While we're on the topic any reason you've gone B6T rods over BP?
himynameisbunny is offline   Reply With Quote