power windows conversion

[ROB-80E]

uummm...thought all the info was above?

Originally Posted by ROB-80E

You will need:-
- all 4 motor mechs for the doors
- all 4 door wiring harnesses
- all 4 door trims
- switches
- plastic mounting clips for switch on rear doors
- and the loom that runs to the rear doors. It runs from the fuse box at the drivers leg back the the drivers side rear door, it also splits and runs under the two front seats and then back to the rear passenger side door.

The setup is a bit of a pain, but overall it's not too hard i guess. The worst part is when you put it all in and the one of the motors don't work smoothly and/or switches don't work...these are both common problems in the astinas power window setup.

You could leave the rear doors out of the equation and it will work.